What i want to do is to put up walls.
Stud out a concrete wall with french drain.
See pics do i frame the walls right on top of the lip or do i put the frames in front of it frames will essentially be 6 5 inches away from the wall in this case.
Do i put 2 inch rigid foam on the cinder block wall it would be over the drain and then add the stud wall to meet.
We plugged the original dime sized hole but obviously the water still seeps through in that general area it would be fine to leave that area unfinished.
I have been looking for a solution but keep getting french drain external results.
The lip is 2 25 inches high and 6 5 inches deep.
I would not put my bottom plate on top of the gravel of the french drain.
Preferably with metal studs and dry walls.
My basement has a french drain around the perimeter.
Maybe 5 or 6 feet of wall space where you would see water seeping into the drain at times.
To clarify i want to put a stud wall along the edge of the perimeter drain.
You can bump the framing out in front of the drain but you will lose a lot of space that way.
The water seeps into the french drain in one corner only.
As for the inside if water get s in and runs down the wall you must have a gap between the framing and the wall to let it run into the drain tile.
Basement is about 50x30 ft.